anglevani™ / Rod transport
RoadCase 4-Piece Rod Travel Tube
Pack a four-piece rod one section at a time.
Loose rod sections can rub against one another even inside a hard case. RoadCase combines a rigid outer tube with four individual sleeves and cushioned ends. Lay the rod sections out first so you can check the longest section and largest guide before packing.
Separate guides and ferrules
Slide each clean, dry rod section into its own sleeve. Arrange the sleeved pieces so the guide frames sit clear of one another. They should slide into the tube without bending a guide or pushing hard on a ferrule.
Close without compressing the tips
Position the end cushions before fitting the caps. Check that the caps seat freely. The exterior securing strap and carry handle help keep the packed case together on the walk from the car to the bank.
How to use it
- Measure your longest section and widest guide, including any protruding tip hardware.
- Sleeve the sections individually and insert them gently into the tube.
- Fit the cushions, close both ends and secure the exterior strap. Check the closure before lifting by the handle.
Size & fit
- Illustrated outer length
- 22 in (56 cm)
- Outer diameter shown
- 2.8 in (7 cm)
- Packing components
- Hard tube, caps, end cushions, four sleeves and securing strap
Will a 22-inch rod section fit?
The 22-inch figure is an outside measurement. Caps, end pads and sleeves take up room inside. Allow clearance at both ends and around the widest guide when checking your rod against the case.
Care & storage
After travel, unpack any damp sections. Leave the tube open to dry and brush grit from the cap fittings before closing it for storage.




