Skip to product information
1 of 5

My Store

anglevani™ BenchSpin Manual Reel Line Spooler

anglevani™ BenchSpin Manual Reel Line Spooler

Regular price $49.99 USD
Regular price Sale price $49.99 USD
Sale Sold out
Taxes included.
Quantity

anglevani™ / Line preparation

BenchSpin Manual Reel Line Spooler

Turn a table edge into a spooling station.

A loose supply spool tends to travel across the bench just as you start winding. BenchSpin holds it on a horizontal shaft, leaving you free to turn the reel and watch how line feeds onto it. Set it up where you can see both the supply spool and the reel face.

BenchSpin Manual Reel Line Spooler — Clamp pads, spool supports and adjustment knob
Clamp pads, spool supports and adjustment knob.

Center the supply spool

The tapered supports sit at the spool hub. Bring them inward until the spool runs true, then use the end knob to set light resistance. The spool should turn as you wind and settle when you pause.

Protect the work surface

The C-shaped frame reaches around a flat bench edge. The padded faces spread contact over the surface while the screw beneath the bench draws them together. Leave room to turn the knob and space beside the bench for the spool.

BenchSpin Manual Reel Line Spooler — Bench clamp and shaft configuration comparison
Bench clamp and shaft configuration comparison.

How to use it

  1. Seat the clamp fully on a stable, flat edge and tighten by hand.
  2. Slide the supply spool onto the shaft, center it and check that it clears the upright.
  3. Thread your reel according to its instructions. Wind a few turns slowly, then adjust resistance if the spool overruns.

Size & fit

BenchSpin Manual Reel Line Spooler — Frame measurements and stainless steel shaft
Frame measurements and stainless steel shaft.
Frame height shown
3.9 in (10 cm)
Horizontal span shown
4.7 in (12 cm)
Material details
Metal frame and stainless steel shaft

Will it fit my worktop and spool?

Check the bench lip, spool hub and spool width before ordering. The illustrated outside frame dimensions describe the unit. The clamp opening and usable shaft length are separate fit measurements.

Care & storage

Remove the spool when finished. Wipe the shaft and clamp pads free of dust and line fragments. Store the cones and end knob together so they are ready for the next line change.

View full details