Skip to product information
1 of 5

My Store

anglevani™ FlyLine Loop Keeper Board

anglevani™ FlyLine Loop Keeper Board

Regular price $40.99 USD
Regular price Sale price $40.99 USD
Sale Sold out
Taxes included.
Quantity

anglevani™ / Leader management

FlyLine Loop Keeper Board

Pack each leader so its ends are easy to find.

A pre-tied leader is most useful when you can take it out without uncoiling the one beside it. The Loop Keeper Board gives you rows of slots and two retaining strips in a flat format. Set up a separate path for each rig before you leave the tying bench.

FlyLine Loop Keeper Board — Slotted board, green retainers and corner clip
Slotted board, green retainers and corner clip.

Route each loop separately

Lay the board flat and choose two slots for the ends of the first leader. Follow the rounded edges with loose turns. Leave enough slack to lift one loop without pulling an adjacent leader out of position.

Keep the wraps in view

The green retaining strips hold the wraps against the face. You can trace a leader before releasing it, then secure the remaining wraps again. The corner attachment lets you keep the board in a consistent place in a vest or tackle bag.

FlyLine Loop Keeper Board — Open board beside a compartment organizer
Open board beside a compartment organizer.

How to use it

  1. Untwist and dry the leader before winding it onto the board.
  2. Seat the ends in separate slots and slip the retaining strips over the loose wraps.
  3. To retrieve a leader, lift its strip and unwind along the same path in reverse.

Size & fit

FlyLine Loop Keeper Board — Board dimensions and retaining strip details
Board dimensions and retaining strip details.
Board length
5.3 in (13.5 cm)
Board width
2.9 in (7.4 cm)
Profile shown
0.2 in (0.5 cm)
Board material
ABS plastic

Can I use the corner clip to carry other gear?

Use the attachment for carrying the board. Keep heavier tools on their own attachment points so they cannot load the board or pinch the line.

Care & storage

Rinse away sand and let the board and strips dry separately. Run a fingertip along the slots before reloading to check for grit that could mark a fine leader.

View full details